Manual For Silverson L5m Homogenizer ((TOP))
CLICK HERE ---> https://fancli.com/2tgYdo
Technical Information Laboratory Mixers Model L5M-A All dimensions shown are in inches. The dimensions shown are approximate only and certified diagrams should be used for installation purposes. Silverson reserves the right to change dimensions and specifications without notice. www.silverson.com For more information or a free trial call us at +1 (413) 525-4825
In-Line mixing assembly The In-Line assembly fits on to the model L5 Series Laboratory range and converts it into an in-line mixer/homogenizer. The centrifugal action of the rotor in the high shear rotor/stator workhead generates a nonpositive pumping action which gives a throughput on low viscosity liquids of approximately 20 liters/minute, reducing as the viscosity increases. The In-Line assembly is suitable for use at atmospheric pressure only. It is not recommended for use on abrasive, corrosive or flammable materials. Specialized mixers L5 Sealed unit laboratory mixer Designed for...
Silverson offers a range of in-tank and In-Line mixer homogenizers for these applications. The precision-machined Silverson workhead generates exceptionally high shear rates in a three stage process that rapidly homogenizes the product to the required uniformity.
For the few applications that demand submicron particle or globule sizes a high-pressure homogenizer may be required. Where this is the case, passing the product through a high shear Silverson Mixer Homogenizer first will dramatically improve throughput, process efficiency and reduce operating costs. This is because a high-pressure homogenizer works better when fed with a premix of uniform and fine globule or particle size, allowing the product to pass through the homogenizer at a much faster rate, normally in a single pass. 153554b96e
https://www.darkha.com/en/forum/bienvenido-al-foro/h-games-chronicles-of-prey-2-ver2-0-19-better